Glanzer Performance

Glanzer Performance Hobbyist looking to help provide an affordable & reliable alternative to the speed enthusiast or jus

Seth had us take a look at his tune before his race in St Louis. We were able to sneak some more power out of it and be...
04/13/2026

Seth had us take a look at his tune before his race in St Louis. We were able to sneak some more power out of it and be even safer on the fuel and timing.

Who doesn’t have a soft spot for GM square bodies? Jeremy over at Kannas Automotive & performance finished up a few thi...
04/01/2026

Who doesn’t have a soft spot for GM square bodies? Jeremy over at Kannas Automotive & performance finished up a few things for this customer and then had us give it a Dyno tune through a Holley Sniper.

Nothing like almost 500 whp in a family 4dr. Taylor is more than happy with the results! When you buy the right parts...
03/31/2026

Nothing like almost 500 whp in a family 4dr. Taylor is more than happy with the results! When you buy the right parts and they all work together this is what you get!
Milled heads
ORRSOM intake
RCR ported intake manifold
Ported Throtte body
BTR Red Hot cam
Kooks long tubes with full exhaust

Chad’s 2024 camaro putting down some very solid numbers for headers, MSD intake, 103mm TB and air intake.
03/31/2026

Chad’s 2024 camaro putting down some very solid numbers for headers, MSD intake, 103mm TB and air intake.

Kohen made the trip all the way from Lincoln,NE to have us do a cam swap on his Pontiac g8. For headers, intake and BTR...
03/30/2026

Kohen made the trip all the way from Lincoln,NE to have us do a cam swap on his Pontiac g8. For headers, intake and BTR Red Hot cam. You can’t complain with the gains!

Kris took the 7 hr drive to have us tune this one of a kind swap. 6.0L w/ BTR red hot cam, 4L80 with a magnuson superch...
11/14/2025

Kris took the 7 hr drive to have us tune this one of a kind swap. 6.0L w/ BTR red hot cam, 4L80 with a magnuson supercharger. 427 to the wheel in this little guy. Makes it a riot to drive! Tuned on Holley terminator 😎

Wade brought us his sweet 3 door Burban for a tune. After he swapped in a LT 6.6L gas with a 6L90 trans. The absolute ...
11/03/2025

Wade brought us his sweet 3 door Burban for a tune. After he swapped in a LT 6.6L gas with a 6L90 trans. The absolute perfect combo for this ride!

Darwin brought by his super clean Ram Charger. He has this 318 on a Holley sniper and was battling some tuning issues w...
10/23/2025

Darwin brought by his super clean Ram Charger. He has this 318 on a Holley sniper and was battling some tuning issues with detonation. After getting the run around by the other shop and having him chase the transmission as the issue. He brought it out to us and we found the tune to have way to much timing in it. After we got done with it, we picked up quite a bit of low end power and torque over the old tune. Even the customer said it drives so much better than before going down the road.

Ryan brought his g8 that just had a fresh new motor in it. With a custom cam, headers and intake. Solid power for what’...
10/22/2025

Ryan brought his g8 that just had a fresh new motor in it. With a custom cam, headers and intake. Solid power for what’s done , 450whp is perfect and reliable.😎

We got to meet a new customer Joe at the SORC race, with his 2016 C7r z06. He’s been battling this car for quite awhile...
10/19/2025

We got to meet a new customer Joe at the SORC race, with his 2016 C7r z06. He’s been battling this car for quite awhile. We were able to get the tuned squared away while I was down there. The car drove so much better and pulled so much harder. But we still were having LT4 heat soak issues. Joe brought it to us and we put a interchiller on it, DSX lid and aux coolant tank. Now heat soaking is out of the question.

Justin just bought this super clean g8 from down south and he wanted us to check over the tune because something seemed ...
10/19/2025

Justin just bought this super clean g8 from down south and he wanted us to check over the tune because something seemed off. Well after a fresh set of plugs in it. It was making 407whp. Then we tuned it and brought it up to 435 and got the trans shifting like it’s suppose to. 😎

Address

106 N. Western Avenue Suite A
Hartford, SD
57033

Opening Hours

Monday 8am - 5pm
Tuesday 8am - 5pm
Wednesday 8am - 5pm
Thursday 8am - 5pm
Friday 8am - 5pm

Telephone

+16054963538

Website

Alerts

Be the first to know and let us send you an email when Glanzer Performance posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Glanzer Performance:

Shortcuts

Share