Independent CNC Programmer

Independent CNC Programmer Programming, and estimating lasers and turrets is a skill I regularly perform at my daily job, as we

Pushing the limits of an Amada Vipro.While working with one of my customers we found that the clamp dead zone is smaller...
12/07/2025

Pushing the limits of an Amada Vipro.

While working with one of my customers we found that the clamp dead zone is smaller that the manual says. By adding the arcs in the clamp dead zone graphics, we can add part punch hits that normally would be in a dead zone. This has gained more parts per sheet and helped reduce cycle time.

Using WE-CIM software to generate incremental numbered tags fully tooled for laser cutting. This was done by generating ...
07/20/2025

Using WE-CIM software to generate incremental numbered tags fully tooled for laser cutting. This was done by generating the tag and each number to be merged into a completed file and saved under the tag number. In a matter of minutes several hundred tags can be made for nesting as seen.

A customer wanted a one-page setup sheet portrait orientation.
06/09/2025

A customer wanted a one-page setup sheet portrait orientation.

Cost saving from one part file to eight part nest.
04/05/2025

Cost saving from one part file to eight part nest.

Address

355 E Church Street
Urbana, OH
43078

Telephone

(937) 215-2353

Website

Alerts

Be the first to know and let us send you an email when Independent CNC Programmer posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Independent CNC Programmer:

Shortcuts

Share

Category