Mack Creek Machining & Welding

10/23/2024

Little but big project! Press fit for a roller bearing. Shaft was 5 ft long.

03/13/2024

Mostly personal machining projects lately. Adding some doors to my sandrail getting long travel rear suspension and a transaxle freshen up with new seals and new bearings.

10/19/2023

Got my desk set up in the corner little progress is always good!

10/06/2023

Just made a bench tool holder for putting my cat 40 tools in to remove the cutting tools from

10/05/2023

06/03/2023

Was supposed to get this 8 yrs ago. Finally got it. Feels good to be USA certified!

12/08/2022

A shaft that i just repaired.

11/19/2022

Finally after many hrs of tinkering and working on it its doing a warm up! Still some minor issues but nothing to bad. After a small fire and a replacement pcb board! Things are looking up!

11/07/2022

Was a busy weekend getting my phasematic phase converter wired up 40 Hp that i got a great deal on and works good now ill be able to run my knee mill. Still need to wire up a smaller sub switch for it rather than a ext cord coming out of main box but will in do time. 200 amp service to phase converter with a 400 amp feed service total. Slowly getting things going for the shop!