American Sheet Metal Equipment

03/30/2023

FOR SALE: $20,000 or best offer

This 2005 HAAS TM2 Vertical Machining Center is a great choice for any shop looking for a toolroom CNC mill. It has a 40" X-axis travel, 16" Y-axis travel, and 16" Z-axis travel, allowing for a wide range of machining operations. The rapid rate for each axis is 200 IPM, and the maximum table load is 1,000 lbs. The spindle motor is 7.5 HP and the spindle speed is 4,000 RPM, with a 40 CT spindle taper. The machine also has a 10 ATC tool changer. This machine is in good condition and is available immediately. Toolholders are not included, but the machine does have a HAAS CNC control. This is a great machine for any shop looking for a compact 3 axis CNC machine.
Brand: HAAS
Model: TM2
Year: 2005
Category: CNC Mill

Specs as follows:
X Axis Travel: 40"
Y Axis Travel: 16"
Z Axis Travel: 16"
Rapid Rate X Axis: 200 IPM
Rapid Rate Y Axis: 200 IPM
Rapid Rate Z Axis: 200 IPM
Max Table Load: 1,000 LBS
Spindle Motor: 7.5 HP
Spindle Speed: 4,000 RPM
Spindle Taper: 40 CT
Tool Changer: 10 ATC
Rigid Tap (Available through Haas)
3.5" Floppy Drive
Coolant Pump Kit
Table Size: 57" x 10"
Dimensions: 100" x 64" x 100"
Weight: 5,200 LBS

Run Time: 3620 Hours

Options: HAAS CNC Control, Extended Enclosure

08/05/2021

This customer manufactures a wide variety of School Buses and other Commercial Transportation Units. We manufactured a Coil Feed Rollform Line to punch, rollform, and cut-to-length a wide variety of Roof Trusses primarily for their School Bus Line. After the Roof Trusses were rollformed they would put two (2) lengths into an old Radius Form Press that would form them into a contour radius the height and width of the Bus.

This unit was approximately 30 years old and the manufacturer no longer built machinery. The machine design was a little unconventional but produced parts for years and the customer asked if we could rebuild the machine and update the Controls for them. The original frame was cracked and needed to be fixed and reinforced. All the Hydraulic Hoses, Cylinders, and Valves leaked and needed to be repaired or replaced. A lot of the Form Tooling, Bushings, and Guides needed to be reworked or replaced. A new PLC was added along with a lot of the Switches and Sensors.

We hard piped a lot of the Hydraulics and eliminated a lot of the Hoses and leakage problems.

It is not shown on the photo but we also built Safety Guarding for the System which was virtually non-existent before our rebuild.

08/05/2021

08/05/2021

Used Tag Production System for sale. https://americansheetmetalequipment.com/used-machinery/

07/23/2021

Twenty (20) station Independent Stand Rollformer to produce 14 GA. post section.

07/22/2021

The Dual Head Rollformer is designed to form two (2) edges
of the strip or part at the same time in a single pass
through operation.

07/20/2021

30 - 40 Series Decoiler