Welding Works

10/25/2026

Petsafe needs to do better. These plastic pcs are awful and repeatedly break. Well if anyone knows me, I will fix it so its fixed. No more stuff falling apart because its cheap. 16 gauge stainless support plates. Let us know if you need some.

10/24/2026

10/18/2026

2026 silverado 2500 LT. 6.6L gas L8T motor.

Very exstensive research and development involved in this build. One off equal length exhaust lengths from driver and passenger sides. Merged into a z pipe, then a valved muffler setup, over the axles to a set of megaphones for accoustics. Bumper was cut out in house for perfect fitment on this 2500. They dont make 2500silverados or 3500 with dual exhaust. This one is special now!

10/01/2026

Gate and post is re-hung properly. Whoever built and installed it did not properly address problems at hand with the post. Post is fixed via a bracket/flower holder.

09/23/2026

Late night in shop today. Small project came in as some repair work along with upgrades. Main bar for swing arm was sleeved by some one prior. And was showing signs of failure again. Completely removed. Installed a 4130 tube. New brackets for swing arms. New bottom protection plate. Made the steering support adjustable. Along with an adjustable seat bracket system to fit a junior seat in this slingshot chassis. Also modified some pedals with some brackets to fit heim joints to them to reach a secondary pedal for shorter people. Brackets will be available through ADK Blast N Coat !!!

09/13/2026

Heres a video of the truck I got to ride in at the burnout comp! Hands down Jerred Murray has a beast of a truck for it. Was a ton of fun while tires lasted haha.

09/11/2026

Customer brought me a templete with dimensions very specific to fit this old show quality camaro. Showing steps from templete to product leaving. Get together with us to get custom parts made!

08/20/2026

Steering box to an old loader. Customer brought it to me because they cant get parts for it anymore and they had tried multiple times to weld the 2 steering shafts together in the machine. Well I ended up tearing entire thing apart to find out even a roller bearing was completely toasted. So ended up replacing/repairing/fixing everything else that was found broken inside of it. Attached a u joint to the shaft for multiple reasons. For easier install/removal and to have strong connection points that also have a little give to them.

08/19/2026

This was an on going job from this summer. It was an honor to work on this property. It was a blessing to see the lake everyday I was there as well. Was a major change to these baseplates. They were very thin copper from about 80 years ago. They been beat up by normal maintenence around the property. And it showed. Now they are replaced with 16 gauge stainless that had been sandblasted by ADK Blast N Coat before installation so the paint had a proper texture to adhere to. Customer asked for them to be seamless appearing as well so they were seam sealed and palm sanded before final paint. Alot of work went into taking care of these properly and no steps skipped.