Outlaw Machining & Fab LLC

Directions Contact the business

Outlaw Machining & Fab LLC Contact information, map and directions, contact form, opening hours, services, ratings, photos, videos and announcements from Outlaw Machining & Fab LLC, Metal Fabricator, Seaman, OH.

Straightened out a Munci 4 speed case for a customer. Someone had previously welded the broken mounts back on and it had...
09/20/2026

Straightened out a Munci 4 speed case for a customer. Someone had previously welded the broken mounts back on and it had low spots, so I built weld up in the low spots then machined the whole surface flat.

I dont normally do drive shafts but was helping a customer out. Tig welded the end yoke on his Strange drive shaft.
09/20/2026

I dont normally do drive shafts but was helping a customer out. Tig welded the end yoke on his Strange drive shaft.

Machined a axle shaft down to accommodate a inner axle seal where customer was getting rid of the central axle disconnec...
09/20/2026

Machined a axle shaft down to accommodate a inner axle seal where customer was getting rid of the central axle disconnect and doing a 1 piece axle a few weeks back for his Ram Cummins pulling truck.

Cage job I bent, notched, and then painted with Rust-Oleum hammer tone paint in a foxbody for a customer.
09/20/2026

Cage job I bent, notched, and then painted with Rust-Oleum hammer tone paint in a foxbody for a customer.

Project I finished up this past week for a customers foxbody restoration. Built a custom upper mount and lower mounts fo...
09/20/2026

Project I finished up this past week for a customers foxbody restoration. Built a custom upper mount and lower mounts for radiator and welded AN fittings in the radiator. Took the front cooler customer supplied and welded AN fittings in it and made custom mounts to mount it to the front tube bumper.

Exhaust manifold off a x15 Cummins motor in a semi I set up in the mill and machined all the ports flat with each other ...
07/27/2026

Exhaust manifold off a x15 Cummins motor in a semi I set up in the mill and machined all the ports flat with each other this past week.

Fab9 all finished up that I built from start to finish for a customer's 1968 Mustang. It's going to look pretty under th...
05/30/2026

Fab9 all finished up that I built from start to finish for a customer's 1968 Mustang. It's going to look pretty under the car. The guys at Cole’s Coatings LLC did an awesome job powder coating the axle, spectacular work as always.

04/12/2026

Saturday night work in the machine shop on parts!

Custom FAB9 for a customers 68 mustang with leaf springs I just built. More pictures to come when it gets back from bein...
04/06/2026

Custom FAB9 for a customers 68 mustang with leaf springs I just built. More pictures to come when it gets back from being powdercoated.

Welded some 3" stainless v-band couplers on kooks headers for a customers foxbody mustang.
02/25/2026

Welded some 3" stainless v-band couplers on kooks headers for a customers foxbody mustang.

Address

Seaman, OH
45679

Website

Alerts

Be the first to know and let us send you an email when Outlaw Machining & Fab LLC posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Outlaw Machining & Fab LLC:

Shortcuts

Share

Category