Fass Fab

Fass Fab Custom metal fabrication.

Mocking up seats and dash. Filling dash smooth before rebuilding, custom seat mounts and console.
05/21/2026

Mocking up seats and dash. Filling dash smooth before rebuilding, custom seat mounts and console.

Driver and passenger door panels clamped in! Now onto transition foot panel to clear the exhaust headers.
05/05/2026

Driver and passenger door panels clamped in! Now onto transition foot panel to clear the exhaust headers.

Driver and passenger footboard skeletons are in! Cut, bead roll and clamp in the footboard panels tomorrow!
04/30/2026

Driver and passenger footboard skeletons are in! Cut, bead roll and clamp in the footboard panels tomorrow!

Mid panel bead rolled and clamped in. Now into the floor foot panels.
04/23/2026

Mid panel bead rolled and clamped in. Now into the floor foot panels.

All vertical panels on. Ready to bead roll mid panels and final weld the skeleton.
04/23/2026

All vertical panels on. Ready to bead roll mid panels and final weld the skeleton.

Excited to finally setup my new Bambu Labs H2C printer! Multicolor, heats, cameras, etc! #
04/21/2026

Excited to finally setup my new Bambu Labs H2C printer! Multicolor, heats, cameras, etc! #

Driver mid firewall Skelton and panel fit and tacked. Onto passengers tomorrow!
04/21/2026

Driver mid firewall Skelton and panel fit and tacked. Onto passengers tomorrow!

Firewall@coming together! Need to make two mid joining panels and footboards! Then onto mapping out steering, plumbing...
04/15/2026

Firewall@coming together! Need to make two mid joining panels and footboards! Then onto mapping out steering, plumbing and electrical! Brad Steed

Drivers and passenger firewall skeleton is in. Making both panels tomorrow, bead roll and clerk into place. Steering r...
04/09/2026

Drivers and passenger firewall skeleton is in. Making both panels tomorrow, bead roll and clerk into place. Steering rack installed and ready to locate the steering though the firewall. Brad Steed

Back in the shop after being overseas for a month. Top cowl panels bead rolled. Designing access panels on the 3d prin...
04/01/2026

Back in the shop after being overseas for a month. Top cowl panels bead rolled. Designing access panels on the 3d printer to put I. Place of the beads. Pull the motor now setting up and planning for front panels on the firewall.

Both upper cowl panels cut and fit! Now to Bead roll and weld on Monday!
02/20/2026

Both upper cowl panels cut and fit! Now to Bead roll and weld on Monday!

Address

Platte City, MO
64079

Website

Alerts

Be the first to know and let us send you an email when Fass Fab posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Fass Fab:

Shortcuts

Share

Category