IMCO Carbide Tool

IMCO Carbide Tool Tools made for the new age in metalworking. Our unique designs run smarter, smoother, and with incre Hard working tools, because they are made that way.

Every benefit of advanced technology goes into every tool, from unique geometries to high-performance coatings. Then they’re tested – In-house and in customers’ operations – to make sure you’ll get the most out of them.

06/19/2026

Wall roughing 4140 steel with a ¼" corner radius.
SFM: 435
RPM: 3,323
IPT: .0022
Feed Rate: 58.5 IPM
Ap: .375"
Ae: .05"
(MRR= 1.1 cu in./min.)

06/17/2026

Deep wall roughing 4140 steel with our M525 end mill.
SFM= 944 RPM
IPT: .003
Feed Rate: 14.2 IPM
Ap: 3.125"
Ae: .035"
(MRR= 1.55 cu in./min.)

06/16/2026

When installing a pull stud, under tension can cause it to come loose, over tension will bell out the holder. Always use a torque wrench set to 110lbs.

06/12/2026

Debunking the myth that when cutting aluminum, the coating on the tool cannot contain aluminum or material will adhere to it during cut.

06/10/2026

Machining inside corners can create "corner spikes" by increasing radial engagement and cutting forces, putting additional stress on the cutting edge and shortening tool life.

06/09/2026

When ramping, you generally need to drop your feed rate to approximately 70% to 75% of your standard slotting IPT/MMPT feed. Once the entry hole is established, you can ramp up to 100% or more of your high-efficiency machining values.

06/05/2026

With High Efficiency Milling you want to use as much of the flute length as possible, if depth of cut is less than 1.5 times D, shoulder milling could be a better option.

06/03/2026

CNC Machining a 4 inch cutting blade for a flail mower out of 6AL-4V Titanium with an edge thickness of .100”.

06/02/2026

We decided to put our POW•R•FEED M935 to the test. We started at our maximum recommended MRR of 6.75 and increased by 20% until we hit a 4x increase, an MRR of 27! Not only did it make all the passes, the cutting edge still looked great!

05/29/2026

You've double checked the spindle and tool holder but are still chasing runout? If you aren’t running IMCO end mills, check that brand new cutter - not all end mills are created equal.

Address

28170 Cedar Park Boulevard
Perrysburg, OH
43551

Opening Hours

Monday 8am - 5pm
Tuesday 8am - 5pm
Wednesday 8am - 5pm
Thursday 8am - 5pm
Friday 8am - 5pm

Telephone

+18007654626

Website

Alerts

Be the first to know and let us send you an email when IMCO Carbide Tool posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to IMCO Carbide Tool:

Shortcuts

Share

Category