PM Machine Worx LLC

PM Machine Worx LLC We’re a job shop for anyone and everyone. No job is too small.

After finishing my main job, I am dedicating my Saturday morning helping to get another bike back out there on the road....
08/11/2024

After finishing my main job, I am dedicating my Saturday morning helping to get another bike back out there on the road. Thank you Matt.

Another one done. I like doing this because every one is a new learning experience. This shaft is out of a hydraulic pum...
02/14/2024

Another one done. I like doing this because every one is a new learning experience. This shaft is out of a hydraulic pump and it’s extremely hard.Glen

11/22/2023

One of the hardest news to accept😪😪 is when the doctor says there’s nothing left to do, there are only two options: sleeping until the body collapses or give morphine to ease the pains." Our world fell apart. I'm looking for those who will have time to read this post until the end. This is a little test, just to see who reads and who shares without reading! If you have read all, select "like" so I can put a thank you on your profile. Cancer is very invasive and destructive to our body. Even after the fight Its a very long process. Please, in honor of someone who died or is fighting cancer or even had cancer, but was healed; copy and paste. Everyone says, "if you need anything, don't hesitate, I'll be there for you."
So going to do a challenge, I think less than half of my friends will put this on their wall. Just copy ( don't share ) I want to know who I can count on Once you're done write "done

A couple of shafts for a Kubota lawnmower. They had been discontinued from the manufacturer.
08/01/2023

A couple of shafts for a Kubota lawnmower. They had been discontinued from the manufacturer.

Thank you daddy for your service to our country.
05/27/2023

Thank you daddy for your service to our country.

05/27/2023
The old spline shaft was very difficult to get any good measurements from but after several test pieces I think I finall...
04/04/2023

The old spline shaft was very difficult to get any good measurements from but after several test pieces I think I finally found the right fit. I had to make it in two pieces because of the internal spline. Thanks to Jeff Britt for the welding and heating the part for hardening.

10/16/2021
14mmx5” long key way in a 10’ shaft.
05/31/2021

14mmx5” long key way in a 10’ shaft.

Address

Metts Rd
Nettleton, MS
38858

Website

Alerts

Be the first to know and let us send you an email when PM Machine Worx LLC posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to PM Machine Worx LLC:

Share

Category