Pro Machine Repair

01/26/2026

Machinists turn raw material into reliable parts—holding tolerances you can’t see, but everything depends on.

We aim for perfection.
That’s the standard.

&Tool

11/26/2025

⭐ WEDNESDAY – Way Cover Damage

A torn or bent way cover lets coolant and chips destroy your machine’s precision components.

A cheap protective fix saves huge repair costs.

11/25/2025

⭐ TUESDAY – Linear Guide Issues

Rough axis motion or chatter marks on parts?
Linear guides may be worn or starved of lubrication.

We inspect rails, trucks, seals & grease paths.

11/24/2025

⭐ MONDAY – Ballscrew Wear

Backlash, noisy travel, or inconsistent dimensions?
Your ballscrew might be wearing out.

We check preload, lubrication, and mechanical play.

11/21/2025

⭐ FRIDAY – Accuracy & Alignment

Is your machine cutting out-of-square or leaving chatter marks?
Proper alignment = better parts + more profits.

We check leveling, geometry, backlash & more.

11/20/2025

⭐ THURSDAY – Drawbar & Tool Change Issues

📣 Tool stuck? Loud popping? Weak tool retention?
These symptoms often mean:
• Weak Belleville springs
• Bad unclamp cylinder
• Low air/hydraulic pressure

Don’t fight tool changes — fix them.

11/20/2025

🚨 PARTING OUT — 1999 HAAS VF-2 🚨
If you need Haas parts, I’m currently parting out a 1999 Haas VF-2. Plenty of good, hard-to-find components available.

📌 Available
• Servo motors & drives
• Spindle & spindle components
• Tool changer parts
• Control boards, keypad, wiring
• Sheet metal & way covers
• Sensors, switches, solenoids
• Pumps, hoses, hydraulics
• And more from a complete machine

💬 Message me the part number or a photo of what you need and I’ll check availability.

📍 Shipping available
🔧 Pro Machine Repair LLC

11/19/2025

⭐ WEDNESDAY – Servo & Drive Alarms

Overload? Overcurrent? “Servo Error Too Large”?
These alarms usually point to deeper problems like bad amplifiers or encoder feedback.

We troubleshoot quickly to get you moving again.

11/18/2025

⭐ TUESDAY – Spindle Problems

Is your spindle louder than usual? Heat, vibration, or poor finish is your machine telling you something. Don’t wait until it fails.

Most common spindle issues:
• Bearing wear
• Taper damage
• Drawbar pressure too low

We diagnose before it becomes expensive.

11/17/2025

⭐ MONDAY – Preventive Maintenance

Start your week strong!
A CNC machine that’s maintained regularly runs smoother, lasts longer, and produces more accurate parts. Preventive maintenance is the easiest way to avoid costly breakdowns.

Here’s what a proper PM includes:
• Lubrication system inspection
• Drawbar pullforce test
• Ballscrew & linear guide check
• Spindle taper clean & inspect
• Backup of parameters/offsets
• Air & hydraulic filter checks

Kick off the week with confidence — message us to schedule a PM service!

11/14/2025