Arrow Performance Fabrication

04/11/2025

Got this 12k Badlands winch all mounted up on this Yanmar compact. We utilized the existing the weight rack to recess the 2in x.120 wall rectangle flush with the chassis, and give a solid point to run a cross tie. We then added 1.75"x 3" straps along the side to give it just a little extra strength.

03/24/2025

EX001 is finally complete ✅️ and has left the building! 💨

This project has been a challenge to say the least, as it is the first Exo Cage order we've ever taken on. The owner wanted no obstruction of any lights or wiper operations and wanted as snug of a fit as possible and we did just that, each bar on this cage has been placed so that all impact points have been considered and tailored to perfectly encase this truck and protect the driver; should a rollover ever happen.
And it looks pretty bad ass, too.
The links between the main tubes are built to correlate with half doors that the owner currently runs.
This rig is no joke! With over 18" of shock travel, a 2 speed transfer case and enough meat on the ground to feed a village, we're glad to provide a cage that will allow the driver to push this truck to its limits.

There's still some availability left in 2025!
Contact us now for any and all fabrication needs to get put on the schedule!

04/09/2024

A little on this foxbody engine bay. We welded up all the little holes and made covers for the inner fenders and frame rails. It really cleaned this daily driver up.

08/31/2023

This 68 Camaro by Guitars n' Cars is going to be one wicked hot rod. With a big block and a 4 speed going in this the customer wanted to make sure the car could handle the fun for years to come with a street strip cage. More to come. Stay tuned!

05/15/2023

05/15/2023

Test & Tune every Thursday at Mooresville Dragway.-Always support your local racetrack so they’ll stay open for youhttps://www.facebook.com/MooresvilleDragwa...

05/15/2023

05/13/2023

Buy tickets to NMRA Norwalk, OH

05/02/2023

It's out with the old and in with the new! Going from a Rouge Fab bender to a JMR Manufacturing bender. With this machine we will be able to bend with a tighter CLR (center line radius) to provide closer fitting cages at a fraction of the time. Message us to get your car on our schedule today!