Cephas Engineering & Geosciences

05/05/2017

05/05/2017

05/05/2017

05/05/2017

05/05/2017

05/05/2017

05/05/2017

05/04/2017

The rheological properties of four different Kuwaiti crude oils in the presence of polyacrylamide (PAA) were investigated. PAA was varied at three different concentrations of 25, 50, and 75 ppm to study the viscoelastic properties in the untreated samples. Four different temperatures (25, 30, 35, an...

05/04/2017

This paper presents the effect of high viscosity oil and two-phase foamy-oil flow on the performance of a single stage centrifugal pump. As a part of this, the applicability of a pipe viscometer to determine the foamy oil viscosity is investigated. Unlike previous studies, a sealed fluid tank is use...

05/04/2017

For the characteristics of horizontal fractures in shallow low-permeability oil layers after hydraulic fracturing in multilayer reservoirs, horizontal fractures are taken equivalent to an elliptical cylinder with the reservoir thickness using the equivalent permeability model; then, upon the ellipti...

05/04/2017

Barium sulfate (barite) is one of the widely used weighting materials in the preparation of drilling fluid for deep oil and gas wells. Barite is not soluble in the regular solvents; such as, hydrochloric acid (HCl) and other acids. Therefore, in this study, we focused on evaluating the dissolution o...

05/04/2017

Knowledge of the orientation of horizontal in situ stresses is important to some areas of oil and gas field development plans. Borehole breakouts observed in image logs and drilling-induced fractures are the main parameters for the determination of the stresses’ directions in situ. In this work, the...