TMSPhil

03/11/2026

Big Dredd getting a custom spec TMS Aliggamentay!!!

With the power we make and the way we put it to the ground we have to make sure it gets distributed evenly and in the correct direction through out the travel of the suspension.

A car that is different from factory spec sometimes needs an alignment different from factory spec.

It’s all in the details

Toland Motorsports LLC

03/10/2026

It was time for a little refresh on the race car before we take it out this Wednesday for test and tune at Darlington Dragway.

✅Flow test injectors
✅Check spark plugs
✅Oil change
✅Fresh fuel
✅Fluid Check
✅Bolt Check
✅Alignment

If you get the chance come watch some clean cars go down the track and swing by the trailer and say hey to the crew at Toland Motorsports LLC

03/10/2026

Spent the day getting ole Dredd prepped for test and tune Wednesday
Toland Motorsports LLC

03/08/2026

“The hardest part of every 30 minute job is the first 6 hours”😂

At least that’s what this pilot bearing had in mind for me today. While installing a Monster Clutches twin disc on ole Pocket Sand today the pilot bearing decided to give me a run for my money.

Once that was said and done, I finished the job off with a full length true dual 3 inch exhaust kit from Speed Engineering and couldn’t be happier with the results. If you know anything about fourth generation F-bodies you know how tight it can be fitting an aftermarket exhaust on those cars, but they engineered this kit flawlessly with exceptional ground clearance and precision bends.

03/08/2026

03/08/2026

1987 C10 making power on our Dynocom Industries hub Dyno.

Truck is LS swapped with a Magnuson super charger kit installed in house at Toland Motorsports LLC

03/04/2026

📣📣📣Public Service Announcement for those that need to hear it !!!

If you ever have to drill out a broken exhaust bolt
1. Make sure you drill out the bolt and not the surrounding material
2. You don’t have to use all 4 inches of your 3 inch drill bit!!

Thank you and GOBBLESS

02/10/2026

THE ONLY THING MOR THREATNIN THAN A GMT800 IS THE OWNER THAT SKINT A BEAR ALIVE FIR HIS HEADLINER

PS: WANNA MAKE YUR GMTEIGHTHUNNIT MOR THREATNIN? GET YOU A CUSTOM TUNE FROM Toland Motorsports LLC!

🫡GOBBLESS🫡

02/10/2026

Another busy day here at Toland Motorsports LLC and little change in scenery for me. I backed out a classic Chevy to pull in a modern Ford for some exhaust goodies.

This Gen 3 coyote got a set of long tubes and x-pipe manufactured by Speed Engineering.

However I didn’t forget about the C10. I’m still steady chipping away and the parts list and it’s down to the final stretch.

• Finished up custom fuel lines
• Test fit headers(also provided by Speed Engineering) to mock up fabrication for custom connection pipes
• Sourced a new serpentine belt to accommodate the ICT Billet accessory drive bracket system as well as the Magnuson supercharger
• In the process of making a custom hot wire kit for the pumps in the dual fuel tanks
• Wiring electric fans

We are in the home stretch so stay tuned!
Speed Engineering

02/06/2026

A quick install of C.H.E Trunnions for an LS build at the shop