A.A. Welding & General Contracting

05/08/2026

Made a track frame press to take care of this master link for a good customer of ours. Work pretty well with the 60ton press!

05/07/2026

Just missing the lazy boy

05/06/2026

So I’ve probably made almost a dozen sets of these ramps that I designed. Typically, trailer companies don’t really put much thought into the ramps. But so far, almost everyone calls a few days after receiving a set saying, “Why don’t you advertise these more? They’re awesome.”

I designed these almost two years ago for a friend who wanted something sleek but tough. I called them the “Fat Man Series” ramps as a gag 🤣. I went with a personal preference of how I like my trailer ramps. I was always annoyed by how bulky most ramps were, or how the C-channel foot would dig down into the asphalt.

That’s how this design came along. typical c- channel design, I made an angle-style tread and added CNC-cut 3/8”–1/2” saddle bars through the middle so they won’t bend over time. They’re also cut to the height of the angle tread to help reduce machines from sliding off the sides.

I also added a full tubular foot with large web supports. With just a little extra thought, you end up with a much better ramp, including a much higher load rating without over-engineering it.

I make these in 4 different variations, available with standard torsion spring assist or optional power, air, or hydraulic assist systems.

3” × 20”+ × 5’ ramps — 10-ton rating
3” × 20”+ × 6’ ramps — 10-ton rating
4” × 20”+ × 6’ ramps — 20-ton rating
5” × 20”+ × 6’ ramps — 25-ton rating

“Since this post has been taking off Starting price $2,300 10tons to give you idea, but Every ramp cost might be a little different to mate up to your trailer, add-ons, market pricing on material (changes weekly). So please either message the page or call if you are really that serious.”

05/05/2026

In house couplers made to spec and installed! Covert that pesky pin on to quick change on the fly! JRB, cat fusion you name it. Our cnc handle 6” of steel cut

04/22/2026

Hello dirt and sun we miss you!

04/22/2026

Family of 4 removed and ready to get rebuilt!

04/11/2026

Got a limb on the bench here! Hand me an end mill stat!

Cylinder feeling bit achy or rod got bumps and bruises? Bring them in for a check and patch up we got you covered!

04/07/2026

Not just your typical In-shop cylinder repair.

We’ll come to you and remove, install, and even modify out in the field.

Also Not your average pack house. We make them

Rods shot? - we make them
Barrel is shredded!!! - we make them
Gland is stuck…… - we make them
Piston split in two?!?! - we make them
Clevis ends are sloppy. - we make them
Seal kit is obsolete? - we make them 
I can’t get this cylinder out of my machine - we come to you get it out.

You name it we make it.

03/21/2026

Customer needed one time use odd ball socket and new one was a fortune and long lead time.

02/13/2026