Endless Fabrication, INC

03/27/2026

It’s been a long day at the shop

03/23/2026

As of right now the trans and rear swaps are complete. My kid painted the under side and engine bay white and the motor a metallic blue. He has a vision!

03/21/2026

Doing a manual 3 speed to 4 speed swap,
New clutch, replacing the rear and springs with a modern 10 bolt, modifying the trans mount to fit the new bell housing, removing the factory under coating, painting the under side and hopefully getting g it all done by Sunday night 😆

03/18/2026

16 Column repairs. The bottoms were rusted through, we cut the rusted section out and welded in a new piece and used a urethane caulk over the grout to prevent water from getting under.

03/08/2026

Made up a new seat bracket for the nova. Changed the angle of the lower seat so it is more comfortable on my back for longer rides. Made this one from 1” chromoly tubing.

02/08/2026

Finished installing the control arms and coil overs. It dropped the front ride height by 1-1/2
And that leave 5 inches of clearance from the headers to the pavement.

02/05/2026

Front end upgrades.
QA1 double adjustable coil overs and tubular upper and lower control arms going in.

01/29/2026

We cut off the 1/16 plate that was bending where the frame connector was welded to the sub frame. Now it’s fully boxed in and welded solid using 1/8 plate

01/22/2026

Another Tacoma repaired and back on the road.

01/08/2026

01/08/2026

For today’s install we had to match the existing rail and replace the front section of this balcony rail due to a tree falling on it.

12/19/2025

Breaking in the second shop dog