12/08/2026
๐๐ข๐๐ญ๐ข๐ง๐ ๐ญ๐ก๐ข๐ง ๐ฌ๐ญ๐๐๐ฅ ๐ฉ๐ฅ๐๐ญ๐๐ฌ: ๐ฐ๐ก๐ฒ "๐๐ข๐ ๐ ๐๐ซ ๐ฆ๐๐ ๐ง๐๐ญ" ๐ข๐ฌ๐ง'๐ญ ๐ญ๐ก๐ ๐๐ง๐ฌ๐ฐ๐๐ซ
For thin steel plates (say, 6m x 2.4m, up to 2 tons), the instinct is to grab one large permanent magnet and lift. Safety riggers know this is risky for;
โข Uncontrolled bending of overhanging plate edges
โข No way to fine-tune holding force
โข Manual on/off switching, no remote control
โข Unsafe for selecting plates from tall stacks
๐ ๐๐๐ญ๐ญ๐๐ซ ๐๐ฉ๐ฉ๐ซ๐จ๐๐๐ก: ๐๐ข๐ฌ๐ญ๐ซ๐ข๐๐ฎ๐ญ๐๐ ๐ฆ๐๐ ๐ง๐๐ญ๐ข๐ ๐๐ง๐๐ก๐จ๐ซ ๐ฉ๐จ๐ข๐ง๐ญ๐ฌ
Multiple electrically controlled magnets spread across the plate instead of one big lift point:
โข Remote operation, fewer people near suspended loads
โข Granular power control
โข Even load distribution โ less bending, less distortion
โข Safer stacking at greater heights, less floor space used
๐๐ฅ๐๐๐ญ๐ซ๐จ๐ฉ๐๐ซ๐ฆ๐๐ง๐๐ง๐ญ ๐ฆ๐๐ ๐ง๐๐ญ๐ฌ (๐๐๐๐ฌ) ๐ฉ๐ฎ๐ฌ๐ก ๐ญ๐ก๐ข๐ฌ ๐๐ฎ๐ซ๐ญ๐ก๐๐ซ โ they hold the load without continuous power (fail-safe if power drops) but switch on/off electrically with full remote control. Lower energy use, less heat, safer multi-point lifting.
Smarter systems, not bigger magnets.
Read this article here for a more detailed treatment: https://suprememagnets.com/blogs/articles/thin-steel-plate-lifting-magnets
See some interesting projects executed over the years for multi-anchoring complex lifting systems
https://suprememagnets.com/collections/lifting-magnets-range/products/epml-plate
