Turn Tru Machining

Directions Website Contact the business

Turn Tru Machining Turn Tru Machining is your one stop shop for Driveshafts, Balancing, Driveshaft Parts & Components and General Machining including Milling.

Turn Tru Machining has recently been purchased by Taylor Engineering and strive to offer top quality workmanship

Do you know we also service and repair PTO shafts. Get your PTO shaft serviced by us to avoid valuable down time! We can...
24/02/2024

Do you know we also service and repair PTO shafts. Get your PTO shaft serviced by us to avoid valuable down time! We can also get your PTO shaft back up to OSH standards with supply and install of new covers

A nuggety job in for repair! And a new disc machined
16/05/2023

A nuggety job in for repair! And a new disc machined

A batch of Jetboat driveshafts assembled and a lick of paint. We keep these in stock in 190mm or 210mm long
27/02/2023

A batch of Jetboat driveshafts assembled and a lick of paint. We keep these in stock in 190mm or 210mm long

14/02/2023

Crankshaft in for some repairs after the front pulley had come loose and caused a bit of grief!

A nice new shaft all machined for this hydraulic ram
19/10/2022

A nice new shaft all machined for this hydraulic ram

20/08/2022

A badly bent mower conditioner was in for some straightening and balancing. We can balance more than just driveshafts!

Replacement PTO shaft for a rubbish truck off to Queenstown
21/07/2022

Replacement PTO shaft for a rubbish truck off to Queenstown

Nice job out the door this week, machining this wrench beam shaft!
08/07/2022

Nice job out the door this week, machining this wrench beam shaft!

A replacement spring eye pin for a Kenworth truck machined and ready to head to Auckland for heat treatment. For any cur...
11/06/2022

A replacement spring eye pin for a Kenworth truck machined and ready to head to Auckland for heat treatment. For any curly job give turn tru a call!

Address

95 Inglewood Road
Invercargill
9812

Opening Hours

Monday 8am - 5pm
Tuesday 8am - 5pm
Wednesday 8am - 5pm
Thursday 8am - 5pm
Friday 8am - 5pm

Website

Alerts

Be the first to know and let us send you an email when Turn Tru Machining posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Turn Tru Machining:

Shortcuts

Sponsored

Share

Category