JMDesign and Small Engineering

04/12/2025

04/12/2025

I just finished making myself a pair of shoes, and they are very comfortable 😁😁😁

11/05/2025

I have finally finished the complete motion gear ready to fit on the traction engine Yeah!!!For a small area on the traction engine , there sure is a lot of ...

06/04/2025

In this video I have finished the big end bearings and straps, and put the connecting rods and big end bearing together,In the next video i will machine the ...

25/03/2025

In this video I have machined the two connecting rods from 1 1/8" round bar,there's a lot of material removed, I'm happy with them

10/03/2025

In this video i finished making the eccentric rods, jigged every thing up, Then made the lifting lever and put it on the jigged up link assembly

08/03/2025

In this video i have made some of the parts that connect the eccentric straps to the valve link, sorry i ran out of time, as i wanted to post this video, in ...

03/02/2025

in this video i have made the links that are part of the valve workings

17/01/2025

I was asked how i set up the parts of the eccentric straps in the milling machine so the join faces were level, so this is how i did it, and it works fine fo...

13/01/2025

In this video I have been working on the eccentric straps and finished one out of the five, hopefully by the next video i will have the rest finished

24/12/2024

In this video I have finished the eccentrics and had a good start on the eccentric straps