KLS Metalworks & Mechanical

KLS Metalworks & Mechanical Contact information, map and directions, contact form, opening hours, services, ratings, photos, videos and announcements from KLS Metalworks & Mechanical, Metal Fabricator, Uckfield.

KLS Metalworks & Mechanical catering to all your steel and mechanical needs, call Kieran on 07947414918 or email [email protected] for all your steel erection/fabrication and mechanical needs

Nice little 22 plate Toyota aygo X in this morning for front discs and pads after being advised on a service by Toyota. ...
02/02/2026

Nice little 22 plate Toyota aygo X in this morning for front discs and pads after being advised on a service by Toyota. Nice fresh set of quality discs and pads fitted 😍, with a nice saving from main dealer prices. Happy customer, happy days🕺

You don’t seem to see many 350z’s on the road and I had the privilege of working on this beautiful machine! Mot failure ...
31/01/2026

You don’t seem to see many 350z’s on the road and I had the privilege of working on this beautiful machine! Mot failure work, two new track rod ends and two bottom ball joint dust covers replaced, whilst I had it in the customer wanted me to fit a new gear k**b that they had, no dramas, good job done, happy customer, happy days🕺

Had another visit from tiny Tim and his lovely Astra van this morning. Old discs were Mot advisory’s two years in a row,...
06/12/2025

Had another visit from tiny Tim and his lovely Astra van this morning. Old discs were Mot advisory’s two years in a row, safe to say they needed doing, not a lot of contact area on the inside of those discs any more!😳 happy customer, happy days🕺

Brought the mighty transit in for a set of glow plugs this morning, one out of four working isn’t bad??😂 surprised she w...
24/11/2025

Brought the mighty transit in for a set of glow plugs this morning, one out of four working isn’t bad??😂 surprised she was still starting. Not sure why ford couldn’t design the inlet manifold with a bit more consideration for accessing the glow plugs, but here we are🤷🏻‍♂️. All ready for the winter months now 💪🏻

Went out to this very well kept Saab 9-3 aero yesterday, at 21 years old this Saab has only covered 13k miles!😳 the cust...
16/11/2025

Went out to this very well kept Saab 9-3 aero yesterday, at 21 years old this Saab has only covered 13k miles!😳 the customer wasn’t happy with his climate control buttons peeling and becoming sticky, they supplied new buttons and it was just a case of me swapping them over, needless to say another happy customer, happy days!🕺

Nice frame recently erected locally for the fine gentleman at CRB Construction a local reputable company!💪🏻 with help fr...
15/11/2025

Nice frame recently erected locally for the fine gentleman at CRB Construction a local reputable company!💪🏻 with help from the mighty staff at Coussens Cranes

Had this nice little juke in for its first service with me today. The customer hasn’t long had this car so we went right...
14/11/2025

Had this nice little juke in for its first service with me today. The customer hasn’t long had this car so we went right through everything. Now to me that air filter looks well over due and the pollen filter wasn’t much better either!🤢. I hope that isn’t the original air filter since 2019! This vehicle has only done 25k miles and if that filter has been neglected it can end up causing unnecessary internal engine wear. Don’t neglect your filters people, cars need more than just an oil change! Needless to say another happy customer, happy days🕺

23/10/2025

Working for Coussens Cranes a couple of weeks back, with this Interesting job lifting roofs down for the carpenters so they can build the next floor of timber frame, before re-fitting the roof. This is there new liebherr Ltc-1050 a 50t city crane where the cab can go up to 8 metres in the air, making this a real handy piece of kit!

Had this insignia in today with a knocking noise, found a lot of play in one of the droplinks, pair of new quality dropl...
23/08/2025

Had this insignia in today with a knocking noise, found a lot of play in one of the droplinks, pair of new quality droplinks fitted and believe it or not the one that pulled apart was the “better” one. Nice and quiet now 🕺

Had this little Nissan Juke in this morning for some MOT failure work. New lower arm and track rod end fitted, big thank...
16/08/2025

Had this little Nissan Juke in this morning for some MOT failure work. New lower arm and track rod end fitted, big thank you to the lovely lot at Simply MOT's Uckfield for carrying out the retest for me today as they don’t normally do retests on Saturdays!😳 Another happy customer, happy days🕺

Decided to give the headlights a polish on the mighty Vivaro, pretty happy with the results 🕺
26/07/2025

Decided to give the headlights a polish on the mighty Vivaro, pretty happy with the results 🕺

Had this beautiful little Seat Arona in for rear discs and pads this morning. Customer complaint of rear discs being cor...
26/07/2025

Had this beautiful little Seat Arona in for rear discs and pads this morning. Customer complaint of rear discs being corroded and making a horrible grinding noise. With the cars first MOT coming up they wanted it to be right! Although this in fact would only be an advisory I believe they made the right decision to renew them, as the rear brakes clearly weren’t working as efficiently as they should! Nice new quality parts fitted, happy customer, happy days🕺

Address

Uckfield

Opening Hours

Monday 7:30am - 4:30pm
Tuesday 7:30am - 4:30pm
Wednesday 7:30am - 4:30pm
Thursday 7:30am - 4:30pm
Friday 7:30am - 4:30pm
Saturday 8am - 4pm
Sunday 9am - 1pm

Website

Alerts

Be the first to know and let us send you an email when KLS Metalworks & Mechanical posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share

Category