Honbear Workshop

Honbear Workshop Contact information, map and directions, contact form, opening hours, services, ratings, photos, videos and announcements from Honbear Workshop, Automotive Parts Store, Unit 8 Albion Business Park Spring Road, Smethwick.

Motor Racing Dash Installation
21/08/2026

Motor Racing Dash Installation

Full of Drugs!!!
14/08/2026

Full of Drugs!!!

13/08/2026

Honda Civic EJ9 B16A Dyna Run. It is good to produce almost 170ps on a stock B16A

10/08/2026

Honda Civic EJ9 B16A
LinkECU COP conversion completed!

Ready for Telford JDM Car Show!!
09/08/2026

Ready for Telford JDM Car Show!!

Mini coil over cover broken. Rear brake near the limit. Changed before MOT!! #香港人車房
08/08/2026

Mini coil over cover broken. Rear brake near the limit. Changed before MOT!!


#香港人車房

07/08/2026

Engine started!!!

LinkECU conversion (Part 2)Loom almost finished. Wideband o2 sensor installed. Old marrowband was stuck and thread was b...
06/08/2026

LinkECU conversion (Part 2)

Loom almost finished.

Wideband o2 sensor installed. Old marrowband was stuck and thread was broken. No problem, we can fix.

Hope tomorrow the car will start!


#香港人車房

Honda Civic EJ9LinkECU and COP conversion (part 1)Owner would like to have more clean loom and we help to rebuild and re...
06/08/2026

Honda Civic EJ9

LinkECU and COP conversion (part 1)

Owner would like to have more clean loom and we help to rebuild and removed any unnecessary from the car. Later on, will build up the COP and install LinkECU




#香港人車房

It's a long storyCustomer told S2000 cannot start with Stock ECU unless disconnected Crank Sensor. And changed 3 crank s...
03/08/2026

It's a long story
Customer told S2000 cannot start with Stock ECU unless disconnected Crank Sensor. And changed 3 crank sensor still no luck.

His S2000 leave another garage for few months but still no luck....

In our side, the very first thing, we put a LinkECU to check the trigger Scope on sensor. Found that the sensor signal is good. However we found that the timing was off 20ish degree. So we aim on crank and cam position.

As it needs to take off the oil pan, why not do some maintenance on timing chain. We help to replace the timing chain and valve clearance job. Oil change in one shot.

Finally we found the problem. The cam position plant on intake was broken, that's why it off. Lucky we have spare parts and help to replace the Camshaft. The car started beautifully!!!

We need to do rest of the job and will back to the owner.

See you next time!!





#香港人車房
#香港人改車

Address

Unit 8 Albion Business Park Spring Road
Smethwick
B661LY

Website

Alerts

Be the first to know and let us send you an email when Honbear Workshop posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share

Category