22/04/2026
👌Top Troubleshooting Tips here from Pacer Pumps
View Dual Pumps Pacer Products: https://bit.ly/4u62oXC
🔧 Is your pump refusing to prime or move liquid? Don't panic — here's where to start.
It's one of the most frustrating moments on a job site or farm: you fire up your pump and nothing happens. Before you assume the worst, work through the basics. Most priming issues come down to a handful of common causes.
Here's what to check:
💧 Did you prime the pump? Fill the pump casing with clean liquid before starting. It sounds simple, but it's the most overlooked step.
🔩 Check your suction line for air leaks. Use 6-10 wraps of Teflon tape or liquid Teflon on all fittings. Hand tight plus one full turn. Inspect hose couplings for worn gaskets and replace any damaged lines.
⚙️ Verify your RPM and horsepower. Compare your pump's requirements against your engine or motor specs — and make sure your engine is off idle.
📏 Watch your suction lift. Maximum lift is 25 feet at 3,800 RPM. Keep your suction line under 25 feet — industry standard is 20 feet. Remember that high elevation and high temperatures can reduce suction lift further.
🗑️ Look for obstructions. Clear your suction line and strainer, confirm all valves are open, and inspect the impeller for debris.
🔌 Check motor wiring and rotation. Incorrect wiring or rotation will prevent pumping entirely — consult a qualified electrician if needed.
🔍 Still no luck? Open the pump end and inspect for worn or damaged internal parts. Catching wear early saves you time and money down the road.
At Pacer Pumps, we build equipment designed to last — and we're committed to helping you get the most out of every pump in your operation.
📩 Have a technical question? Reach out to our team or visit www.pacerpumps.com
