CPB Marine

02/04/2026

New ignition installed and clean up of corroded connections on the panel and all up and running again🙏.

02/04/2026

Callout to a failed ignition due to corrosion.

01/04/2026

Callout to a gearbox with no drive. Gearbox filter seal failed, Resealed and refilled with fluid, up and running again🙏

31/01/2026

Callout to a barge taking on water 😬😬

31/01/2026

Faulty switch and leak found on the system

30/01/2026

01/11/2025

Happy Halloween from CPB Marine

30/10/2025

Callout to engine cutting out. Please remember to remove old seals from the CAV filters when replacing with new. There are 4 seals to be replaced.

23/10/2025

Callout to a issue with charging. Alternator bolt was over tightened and broken.

23/10/2025

Callout to engine noise and vibration, Must have took some force to bend all 4 engine mounts.

04/12/2024

Callout to a stern gland nut that had been over tightened not knowing that there was another bolt under, they had only been adjusting this 1. SNAP!!. Nightmare access, no good angle, no bolt extractor would work as it was fully stuck in..just about managed to drill and tap to get the job done. 😅😅.
Remember when adjusting your gland there is 2 nuts to tighten, tighten them equally and not so tight that you cant spin your prop with your hands. Then grease. 👍👍