All Things Metal LTD

Directions Website

All Things Metal LTD Metal fabricator based down in Kent. Going from little repairs to Research and Development projects.

Need a log holder for coming into the colder months? We can offer you any size you like and then finished in whatever co...
28/08/2026

Need a log holder for coming into the colder months? We can offer you any size you like and then finished in whatever colour tickles your fancy.

13 forklift battery charger stands complete, ready for some safety yellow powder coat from the boys Performance Powder C...
27/08/2026

13 forklift battery charger stands complete, ready for some safety yellow powder coat from the boys Performance Powder Coating

Another bucket refurb complete✅. This 14 tonne digging bucket was in a bad way, very thin and caved in floor, cracks aro...
08/08/2026

Another bucket refurb complete✅. This 14 tonne digging bucket was in a bad way, very thin and caved in floor, cracks around the tooth adapters and worn out side cutters. So it’s had a brand new floor, wear bars underneath and wear plates on the sides, new side cutters and cracks all repaired.

2 new lifting frames fabricated for these breaker switch cabinets, far more robust then the original stand they were on,...
06/08/2026

2 new lifting frames fabricated for these breaker switch cabinets, far more robust then the original stand they were on, with two different ways to lift them. These will be load tested to be certificated then sent to the galvanisers.

Just a couple simple generator exhaust extension pipes for a Genset in Rotterdam.
31/07/2026

Just a couple simple generator exhaust extension pipes for a Genset in Rotterdam.

This 20 tonne bucket came in for a new tooth adapter as somehow the previous one had been snapped off.
16/07/2026

This 20 tonne bucket came in for a new tooth adapter as somehow the previous one had been snapped off.

This 30 tonne digging bucket in for just some side wear plates as the left hand side had been ripped off and the right h...
16/07/2026

This 30 tonne digging bucket in for just some side wear plates as the left hand side had been ripped off and the right hand side was on its way too.

Custom fabricated Genset control electrical cabinet. This Genset has had a full restoration of replacing everything with...
15/07/2026

Custom fabricated Genset control electrical cabinet. This Genset has had a full restoration of replacing everything with modern equipment making it better than brand new over 20 years ago.

Transit van bulkhead shelving fabricated with very secure fixing points for maximum pull force from the winch. Bottom pa...
06/07/2026

Transit van bulkhead shelving fabricated with very secure fixing points for maximum pull force from the winch. Bottom part of the racking is designed to fit 5 Jerry cans, 2 batteries then 2 20L plastic drums. Also extended the ramp for a more suitable incline with giving it a place to be stored aswell. Also a massive thanks to for slipping us in 🤩.

Another little bit of work on this recovery truck, subtle but finishes the rear and off, capping the ends and adding som...
30/06/2026

Another little bit of work on this recovery truck, subtle but finishes the rear and off, capping the ends and adding some nylon wear sliders to prevent the same thing happening again.

Address

All Things Metal, Mallard Farm, Shelvin
Canterbury
CT46RL

Opening Hours

Monday 8am - 5pm
Tuesday 8am - 5pm
Wednesday 8am - 5pm
Thursday 8am - 5pm
Friday 8am - 5pm

Website

Alerts

Be the first to know and let us send you an email when All Things Metal LTD posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share

Category