Mal's Engineering and Fabrication

Mal's Engineering and Fabrication Specialise in marine and vehicular Fabrication

Modified an LPG tank and converted it to petrol for a customers ‘34 Chevrolet coupe, utilising the existing mounting poi...
08/08/2026

Modified an LPG tank and converted it to petrol for a customers ‘34 Chevrolet coupe, utilising the existing mounting points, fitted new -6 fuel lines and a 600 DP Holley carburettor 👍

Two new hot water systems with all new plumbing fitted in a 110’ Sunseeker motor yacht, customer very happy, installatio...
24/07/2026

Two new hot water systems with all new plumbing fitted in a 110’ Sunseeker motor yacht, customer very happy, installation was very tight😂😂😂

More photos of Port Stephen’s security gate assembly 👍
24/07/2026

More photos of Port Stephen’s security gate assembly 👍

Custom stainless steel exhaust mixer made sample as sample supplied 👍
18/07/2026

Custom stainless steel exhaust mixer made sample as sample supplied 👍

Security gate powder coated and installed on unit block in Port Stephen’s 👍
18/07/2026

Security gate powder coated and installed on unit block in Port Stephen’s 👍

More works on factory in Port Stephen’s, sheeting on walls and two post hoist installation 👍
18/07/2026

More works on factory in Port Stephen’s, sheeting on walls and two post hoist installation 👍

Custom stainless steel flush hatch installed, customer very happy👍🥃🥃
25/06/2026

Custom stainless steel flush hatch installed, customer very happy👍🥃🥃

Another big week done, a custom made security fence and gate installed in Port Stephen’s before being removed again befo...
19/06/2026

Another big week done, a custom made security fence and gate installed in Port Stephen’s before being removed again before powder coating 👍🥃🥃

Just a small job on GMC 3500 truck, replaced drivers front floor pan, definitely needed it😂😂😂
13/06/2026

Just a small job on GMC 3500 truck, replaced drivers front floor pan, definitely needed it😂😂😂

Manufactured a stainless steel hatch to replace a sliding hatch , designed to fit inside existing cavity on a 76’ motor ...
30/05/2026

Manufactured a stainless steel hatch to replace a sliding hatch , designed to fit inside existing cavity on a 76’ motor yacht, top side being covered in teak panelling, underside had to be hand polished to mirror finish👍

Address

Sydney, NSW

Telephone

+61438722378

Website

Alerts

Be the first to know and let us send you an email when Mal's Engineering and Fabrication posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Mal's Engineering and Fabrication:

Shortcuts

Share

Category