Norton Engineering

20/03/2026

20/03/2026

Repair on a Riviera bow rail, bent section cut off, new section spliced in and welded then polished on site.

steel

25/08/2025

Couple of tube bends for a customer, 32mm x 1.6mm stainless steel. Get in contact with us for any tube bending or rolling needs. We can bend up to 32mm (1.25 inch) and roll up to 63mm (2.5 inch).

14/08/2025

Dialing in some settings on our new Envy on some 1.6mm Aluminium….So easy to control heat and pe*******on, very impressive machine.

Get in touch today for any of your Aluminium projects!

14/08/2025

Little final inspection before this science/medical prototype goes out the door. Testing out the low start/spot functions on our new Envy. No laser required for this one, screen is 0.4mm thick 0.8mm holes!

11/08/2025

Early morning start replacing this motor and impeller on an industrial vacuum sealer. While the old motor was still functioning we were able to diagnose that the bearings were near the end of their life and prone to failure.

Repair was completed with no down time for the customer.

Get in touch for any maintenance or repair items in your business.

07/08/2025

We recently got our valued customer making boxes again by sorting out an encoder fault on this box making machine. If your business is suffering from down time get in touch!

01/08/2025

One off’s and Prototyping.

Have a broken part that you can’t get in time or at all?

We can help. We have the tooling and knowledge to reverse engineer just about anything if a repair is not viable. Get in touch if your business is suffering from a lack of reliable spare parts.

01/08/2025

Processing table to expand capacity.

A few pictures of a processing table we designed, fabricated and installed for our customer to double their processing in this specific area.

Get in touch with us if you have a project in mind to improve your business!

01/08/2025

WOS - workplace organisation and standardisation.

It can be the little simple things that can make a big difference to your business and employee satisfaction.

While on site with our client I mentioned re mounting the pictured waste plastic catcher off the wall. They thought it wasn’t possible and had put up with the unsightly and awkward position it ended up during a recent refit. The result is easier access to the conveyor, easier access to removing and replacing the bag when needed, and easier cleaning of the area due to the removal of the feet. And it just looks a whole lot nicer!