Fyber Labs

23/04/2018

And our final 2018 project - https://t.co/CgJSCGo2Hg Which is another partnership with the Blockchain Philanthropy Foundation. We hope to figure out a reliable/safe cryptocurrency wallet system that can complete transfers while not connected to the Internet.

Research a secure way to handle peer to peer transactions between wallets that eventually with sync, but are not connected to the Internet (blockchain network). Develop cheap and easy to use wallets that can trade without additional hardware.

23/04/2018

Our so far most popular 2018 project is the https://t.co/RxzB0OL8eq we plan to sell it on when finished as we have with many of our previous Hackaday projects. It should work well for high power drones or any motorized projects.

We will be utilizing a TI multicell charger and balancer chip along with shared package transistor pairs to produce a small USB charger design that could fit onboard a drone or other small systems.

23/04/2018

Another 2018 project - https://t.co/jwKEx6OiF1 . We are making a new Uno sized platform with better programming and debugging capabilities.

Implement an Uno sized USB based power and programming platform that supports most processors and Arduino shields. We are shooting for Black Magic Probe integration and only needing to swap out cheap daughter board modules.

23/04/2018

We are announcing our new 2018 projects. In partnership with the Blockchain Philanthropy Foundation, we are developing an open source payment gateway system -

Utilizing some trading libraries and transaction monitoring, charities should be able to accept cryptocurrency donations and convert cryptocurrency equivalents for fiat currency for projects.

09/04/2018

Anybody try Chip Quik's thermally stable solder pastes - https://t.co/o38filrTmB ? We have been experimenting, but see some slump issues.

03/03/2018

Ugh, a whole panel needs heat gun repaired. We got a bad batch of LLA215R71C104MA14L that all short across the caps. Luckily, we have some old stock of Samsung CL21.

16/02/2018

Yeah, I just did a STM32 UFBGA design and we used a fab our assembly house got a quote from, but it seemed to good to be true. It was supposed to be one week turn around, but became three before it shipped. I am guessing they outsourced it...

“ I wish I had time to get more quotes from places that don't have online quote capability. That is unfortunately very risky because they tend to give you a quote and then say in the last second that they actually can't make the PCB you need. >_

19/12/2017

Current attempt to make cat safe Christmas tree lights. https://t.co/p4iAkr0zSo

“Current attempt to make cat safe Christmas tree lights. https://t.co/p4iAkr0zSo”

08/12/2017

Finally making a new jig for our Pulse (oximeter) Flex Module. Hopefully these test pins last longer. https://t.co/AXw9oiss3b

“Finally making a new jig for our Pulse (oximeter) Flex Module. Hopefully these test pins last longer.”

01/12/2017

Reading up on the new WS2813 LEDs: they refresh fast enough for no flicker, 18mA and 5mA and two quality/brightness levels. Supports down to 3.5V and has a 'backup' second data pin.

30/11/2017

After a rather successful weekend we are sadly out of stock on most of our haptic boards. We are working with our assemblers and hope to have more in the next coming weeks.

26/11/2017

We still have leftovers! Take 16.63% off our whole store till Tuesday!
https://t.co/qdJq1CLG9Q

Fyber Labs is based in Kirkland, WA. We are developing wearable electronics for consumers and makers. Our Flex Module line is available...