RMS - Rebar Machine Sales and Service

RMS - Rebar Machine Sales and Service A major manufacturer of high quality equipment for the fabrication of reinforcing steel.

RMS enjoys a long history that dates back to the early 1960's following the design and introduction of the first automated table top bender to the industry. Since then, RMS products have been used and acclaimed by rebar fabricators, contractors and precast/ masonry companies throughout the world. All machines are built from the ground up in our factory located in Las Vegas, NV.

01/20/2016
A full truckload of rebar benders, radius machine and a spiral machine en-route to Texas.
04/23/2015

A full truckload of rebar benders, radius machine and a spiral machine en-route to Texas.

The RMS Booth at the 2014 National Precast Show in Houston, TX. Brett will be manning the booth this year.
02/13/2014

The RMS Booth at the 2014 National Precast Show in Houston, TX. Brett will be manning the booth this year.

Betty from McNish Steel visiting our WOC Booth.
01/27/2014

Betty from McNish Steel visiting our WOC Booth.

01/27/2014

RMS will attend and exhibit at the upcoming NPCA Show that takes place in Houston, TX from February 13-15. If you are planning on attending, feel free to visit us at Booth 657.

RMS attended the 2014 World of Concrete Convention in Las Vegas. Show here are a sampling of the equipment that was exh...
01/27/2014

RMS attended the 2014 World of Concrete Convention in Las Vegas. Show here are a sampling of the equipment that was exhibited in the RMS Booth.

Address

San Diego, CA

Telephone

+16193901166

Website

Alerts

Be the first to know and let us send you an email when RMS - Rebar Machine Sales and Service posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share