D.Cign

D.Cign đź’» 3D Printing
🖨️ Redoubt (Voron 2) - 350x350x350mm
🖨️ 2 x Annex K3’s - 180x180x180mm
🖨️ Bambu P1S + AMS - 256x256x256mm

3D scanned a piece of a mirror that had fallen off my colleague’s son’s car, sent him the file and he printed it off and...
28/05/2026

3D scanned a piece of a mirror that had fallen off my colleague’s son’s car, sent him the file and he printed it off and slapped it straight on!
His son had just came back from a trip to the UK so I got a bottle of Jeremy Clarkson’s beer for my troubles. That’s going on the shelf!

Straight off the printer and into the bull bar, had to do a little trim due to a hidden weld in the corner. Happy with t...
17/03/2026

Straight off the printer and into the bull bar, had to do a little trim due to a hidden weld in the corner. Happy with the fitment, need to print out an idea for securing it and order some clear ABS.

Toying with the idea of adding a diffuser to the cube lights on the BYD Shark Raid bull bar, even when the lights are po...
15/03/2026

Toying with the idea of adding a diffuser to the cube lights on the BYD Shark Raid bull bar, even when the lights are pointed to the ground they still have a habit of blinding oncoming drivers when turning.
The aim is to carry on the hexagon pattern whilst allowing a clear printed diffuser to click in behind, aiming for a tool free design and install.

Pumped out a few 3D Scanner marker dice, should hopefully make scanning a bit better, hoping it doesn’t lose tracking as...
08/03/2026

Pumped out a few 3D Scanner marker dice, should hopefully make scanning a bit better, hoping it doesn’t lose tracking as often!

Recently installed a 6-Gang 12v Switch Board under the bonnet of the Shark to control my light bar and spotlights, I use...
01/02/2026

Recently installed a 6-Gang 12v Switch Board under the bonnet of the Shark to control my light bar and spotlights, I used the switchboard to eliminate the need to drill holes in my interior to mount switches. Modelled and printed a couple of brackets that push fit into the gap between the air vents and upper dash board. Pretty happy with the fit!

Address

Griffith, NSW
2680

Website

Alerts

Be the first to know and let us send you an email when D.Cign posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share